The cleaning mode of the full-automatic ultrasonic cleaning machine is basically the same. For hardware, it is generally ultrasonic cleaning, ultrasonic rinsing, water rinsing, air cutting, and then passing through the drying tunnel furnace. All cleaning rhythms are controlled by the PLC terminal control system, and the conveying system is cleaned by the mechanical arm basket

在全自动超声波清洗机清洗的时候要注意以下事项：

When cleaning with the full-automatic ultrasonic cleaning machine, pay attention to the following matters:

复位键仅在手动状态下有效，方式选择必须在复位执行完毕后，按暂停键盘有效；

The reset key is only valid in the manual state, and the mode selection must be valid by pressing the pause keyboard after the reset is completed;

当移动架滑块因故障超越行程时，机器将自动停止运行，此时应在手动状态下，用手动方式将滑动块返回正常位置。若在自动运行情况下多次出现上述现象，则应停机检修感应开关及行程开关；

When the sliding block of the moving frame exceeds the travel due to fault, the machine will automatically stop running. At this time, the sliding block shall be returned to the normal position manually under the manual state. If the above phenomena occur for many times under automatic operation, the induction switch and travel switch shall be shut down for maintenance;

磨合期(三个月)后，应将减速器放油清洗及加注新20#机油；

After the running in period (three months), the reducer shall be drained, cleaned and filled with new 20# engine oil;

每4-6个月，应拆去传动部门罩板对滚动轴承和链轮涂覆2#钙基润滑脂及对减速器调换20#机油；

Every 4-6 months, the cover plate of the transmission department shall be removed, the rolling bearing and sprocket shall be coated with 2# calcium base grease, and the reducer shall be replaced with 20# engine oil;

定期停机查抄各部门紧固螺栓，如发明松动应重新紧固，方可继承利用；

Regularly stop the machine and check the fastening bolts of each department. If they are loose, they should be tightened again before they can be inherited and used;

烘干槽：每隔一星期应对烘干旋转桶滚动轴承注黄油(烘干桶侧面有一注油孔)；

Drying tank: Grease shall be injected into the rolling bearing of the drying rotating barrel every other week (there is an oil injection hole on the side of the drying barrel);

自动运转中，关闭区洗篮的地位及传送，只能由机器臂决定。克制人工参与旋转洗篮或搬动清洗。

During automatic operation, the position and transmission of the washing basket in the closed area can only be determined by the robot arm. Avoid manual participation in rotating the washing basket or moving the washing basket.

运转中，操纵职员应凭据控制台上的上、下料指示灯实时上下料(机体上有蜂鸣警示)。

During operation, the operator shall load and unload materials in real time according to the loading and unloading indicators on the console (there is a buzzer warning on the machine body).

感谢您的阅读，此文的文章来源：超声波清洗设备更多的内容和问题请点击：http://senfuai.com我们会继续努力的为您提供服务，感谢您的支持！

Thank you for reading. Source of this article: ultrasonic cleaning equipment. For more contents and questions, please click: http://senfuai.com We will continue to work hard to provide you with services. Thank you for your support!