通过式清洗机是标准化批量生产的，在使用中若出现故障无法使用时，很大一部分原因是保险丝烧了，这也是很多使用者遇到过的多的故障之一。

The through type cleaner is produced in a standardized batch. In case of any failure in use, most of the reasons are fuse burning, which is one of the many failures that many users have encountered.

原来使用正常，如遇到开机后没有动作，则要检查有没有电源显示，如果没有，首先要检查的就是电源座内的保险丝是否损坏。从电源座拔出保险丝，查看有无断裂的的情况。

It used to work normally. If there is no action after startup, check whether there is a power display. If not, first check whether the fuse in the power socket is damaged. Pull out the fuse from the power supply base and check for any breakage.

机器长时间运行或操作不当引起电源线短路都可引起保险丝烧坏，这样的情况下用户只需自己更换保险丝即可。

The fuse can be burnt out due to the short circuit of the power line caused by the long operation or improper operation of the machine. In this case, users only need to replace the fuse themselves.

还有一种有可能是用户接地线与火线或零线混用，并没有接地。因为本机地线是与机器外壳相连接，或者可能是机器短路，元器件的老化引发的短路现象，导致保险的损坏。

Another possibility is that the user's grounding wire is mixed with the live wire or neutral wire, and there is no grounding. Because the grounding wire of the machine is connected to the machine shell, or it may be the short circuit caused by the aging of the machine and components, which may lead to the damage of the insurance.

检测方法：

Test method:

取出保险丝观察，有无断裂情况，用万用表通断档测量有无断开，判定是否需要更换新器件。

Take out the fuse and observe whether it is broken. Use a multimeter to open and close the gear to measure whether it is broken, and determine whether it is necessary to replace a new component.

另外在使用通过式清洗机时应注意的问题：

In addition, pay attention to the following issues when using the through type cleaner:

1.严防线路短路：设备的清洗槽是采用304不锈钢一次冲压成型的，排水口也都做了有效的防水处理。但是在使用时，必须特别注意保持干燥以防线路短路。

1. Strict prevention of short circuit: the cleaning tank of the equipment is made of 304 stainless steel by one time stamping, and the drainage outlets are effectively waterproof. However, during use, special attention must be paid to keeping it dry to prevent short circuit.

2.运行时间不宜过长：通过式清洗机不适合长时间运行，一般运行超过一个半小时必须休息，以确保温度不会过高，清洗槽中必须加入清洗液后才能启动。

2. The running time should not be too long: the through type cleaner is not suitable for running for a long time. Generally, it must have a rest after running for more than one and a half hours to ensure that the temperature is not too high. The cleaning tank must be filled with detergent before starting.

根据清洗任务，如果需要长时间批量进行工作的清洗作业，则可以选择定制我们这里的清洗机senfuai.com，为你提供满意的服务！

According to the cleaning task, if you need to work in batches for a long time, you can choose to customize our cleaning machine senfuai.com to provide you with satisfactory service!