在使用全自动超声波清洗机时有一些需要注意的地方，这些是要时刻注意的，操作不当会多机器造成损害甚至引发事故，那超声波清洗机运行时要谨慎使用什么？看完后操作人员要小心谨慎。

There are some points needing attention when using the full-automatic ultrasonic cleaning machine, which should be paid attention to at all times. Improper operation will cause damage to many machines and even cause accidents. What should be used with caution when operating the ultrasonic cleaning machine? Operators shall be careful after reading.

注意谨慎使用清洗液

Caution: use cleaning fluid with caution

在使用超声波清洗机的时候，须要按照规范要求的顺序进行操作，特别是不可以先开机然后再把清洗液倒进去，这属于违规操作会引发严重的后果甚至会损坏机器，因此一定要先把液体放进去然后再打开开关。同时还应该要顾及到清洗液的成分，如果它含有易燃性质的液体那么一定要在短时间内完成操作，并且全程都要有人监督，不可以离开现场。

When using the ultrasonic cleaning machine, it is necessary to operate in the order required by the specification. In particular, it is not allowed to start the machine first and then pour the cleaning liquid into it. This is an illegal operation, which will cause serious consequences and even damage the machine. Therefore, it is necessary to put the liquid into it first and then turn on the switch. At the same time, the composition of the cleaning liquid should also be taken into account. If it contains flammable liquid, the operation must be completed in a short time, and the whole process must be supervised. It is not allowed to leave the site.

注意使用腐蚀或挥发性清洗液要做特殊处理

Note: corrosive or volatile cleaning solution shall be specially treated

通常情况下是不提倡使用危险性清洗液的，但如果情况比较特殊，强调超声波清洗机厂家须要使用含有腐蚀性或挥发性的液体，那么应该要采取间接的方式来进行妥善的处理。具体的操作方法是在清洗槽里面先加水，然后再另外用一个容器装清洗液并放入需要清洗的物品，然后在它们浸入清洗槽的水里面，用这种方式来进行清洗该也会在同样的效果，又可以保证安全的问题。

In general, it is not recommended to use hazardous cleaning liquid. However, if the situation is special, it is emphasized that the ultrasonic cleaning machine manufacturer needs to use corrosive or volatile liquid, then it should take indirect measures to properly handle it. The specific operation method is to add water to the cleaning tank first, and then use another container to fill the cleaning liquid and put the articles to be cleaned, and then immerse them in the water of the cleaning tank. Cleaning in this way will have the same effect and ensure the safety.

当直接使用易燃液体清洗时，要尽量在短时间内完成清洗工作，并要求操作者不要离开现场。当需要用腐蚀性或挥发性强的清洗液时，可采用间接清洗的方法。即：先在清洗槽内加水，再将所需清洗液倒入适宜的容器内并放入被清洗物，然后将装有清洗液和清洗物的容器浸入清洗槽中，即可开始清洗工作，其效果与直接清洗相同。

When the flammable liquid is directly used for cleaning, the cleaning shall be completed in a short time as far as possible, and the operator shall not leave the site. When corrosive or volatile cleaning liquid is required, indirect cleaning method can be adopted. That is, add water to the cleaning tank first, then pour the required cleaning liquid into a suitable container and put it into the object to be cleaned, and then immerse the container containing the cleaning liquid and the object into the cleaning tank to start the cleaning. The effect is the same as that of direct cleaning.

全自动超声波清洗机运行时要谨慎使用什么？以上便是问题的相关解答了，如果您对此有什么疑问或者对设备有需求，就来我们网站senfuai.com咨询看看吧。

What should be used carefully when the automatic ultrasonic cleaning machine is running? The above is the relevant answer to the question. If you have any questions or need for equipment, please come to our website senfuai.com for consultation.